Cisco Nexus 5596UP 2RU Chassis, with 2PS, 4 Fans, 48 Fixed 10GE Ports (N5K-C5596UP-FA)
Deskripsi
Performance |
● Cisco Nexus 5596UP and 5596T: Layer 2 hardware forwarding at 1920 Gbps or 1428 mpps; Layer 3 performance of up to 160 Gbps or 240 mpps
● MAC address table entries: 32,000
● Low-latency cut-through design that provides predictable, consistent traffic latency regardless of packet size, traffic pattern, or enabled features on 10 Gigabit Ethernet interfaces
● Line-rate traffic throughput on all ports
|
Interfaces |
● Cisco Nexus 5596T: 32 fixed ports of 1 and 10G BASE-T and 16 SFP+ fixed ports configurable as 1 and 10 Gigabit Ethernet and FCoE or 8/4/2/1-Gbps native Fibre Channel; additional interfaces through up to three expansion modules
● Expansion modules
● 16-port 1 and 10 Gigabit Ethernet and FCoE module
● 8-port 8/4/2/1-Gbps Fibre Channel plus 8-port 1 and 10 Gigabit Ethernet and FCoE module
● Unified port module consisting of 16 ports configurable as 8/4/2/1-Gbps Fibre Channel or 1 and 10 Gigabit Ethernet and FCoE
● 4-port QSFP expansion module
● 12-port 10G BASE-T module (Cisco Nexus 5596T only)
● Layer 3 module (Cisco Nexus 5596UP and 5596T only; one per system)
● Layer 3 daughter card (Cisco Nexus 5548P and 5548UP only; one per system)
● Extension through the Cisco Nexus 2000 Series
|
Layer 2 Features |
● Layer 2 switch ports and VLAN trunks
● IEEE 802.1Q VLAN encapsulation
● Support for up to 4096 VLANs
● Rapid Per-VLAN Spanning Tree Plus (PVRST+) (IEEE 802.1w compatible)
● Multiple Spanning Tree Protocol (MSTP) (IEEE 802.1s): 64 instances
● Spanning Tree PortFast
● Spanning Tree root guard
● Spanning Tree Bridge Assurance
● Cisco EtherChannel technology (up to 16 ports per EtherChannel)
● Cisco vPC technology
● Enhanced vPC enable vPC between Cisco Nexus 5000 and 2000 Series as well as between Cisco Nexus 3000 Series and end host
● vPC configuration synchronization
● Link Aggregation Control Protocol (LACP): IEEE 802.3ad
● Advanced port channel hashing based on Layer 2, 3, and 4 information
● Jumbo frames on all ports (up to 9216 bytes)
● Pause frames (IEEE 802.3x)
● Storm control (unicast, multicast, and broadcast)
● Private VLANs
● Private VLAN over trunks (isolated and promiscuous)
● Private VLANs over vPC and EtherChannels
● VLAN Remapping
● Cisco FabricPath
● EvPC and vPC+ with FabricPath
● Cisco Adapter FEX
● Cisco Data Center VM FEX
● Support for up to 24 fabric extenders on each Cisco Nexus 5500 platform
|
Layer 3 Features |
● Layer 3 interfaces: Routed ports on Cisco Nexus 5500 platform interfaces, switch virtual interface (SVI), port channels, subinterfaces, and port channel subinterfaces for a total of 4096 entries
● Support for up to 8000 prefixes and up to 16000 IPv4 and 8000 IPv6 host entries
● Support for up to 8000 multicast routes
● Support for up to 8000 IGMP groups
● Support for 1000 VRF entries
● Support for up to 4096 VLANs
● 16-way equal-cost multipathing (ECMP)
● 1664 ingress and 2048 egress access control list (ACL) entries
● Routing protocols: Static, Routing Information Protocol Version2 (RIPv2), Enhanced Interior Gateway Routing Protocol (EIGRP), Open Shortest Path First Version 2 (OSPFv2), and Border Gateway Protocol (BGP)
● IPv6 Routing Protocols: Static, Open Shortest Path First Version 3 (OPFv3), Border Gateway Protocol (BGPv6), Enhanced Interior Gateway Routing Protocol (EIGRPv6)
● IPv6 VRF Lite
● Hot-Standby Router Protocol (HSRP) and Virtual Router Redundancy Protocol (VRRP)
● ACL: Routed ACL with Layer 3 and 4 options to match ingress and egress ACL
● Multicast: Protocol Independent Multicast Version 2 (PIMv2) sparse mode, Source Specific Multicast (SSM), Multicast Source Discovery Protocol (MSDP), Internet Group Management Protocol Versions 2, and 3 (IGMP v2, and v3), and Multicast VLAN Registration (MVR)
● Virtual Route Forwarding (VRF): VRF-lite (IP VPN); VRF-aware unicast; and BGP-, OSPF-, RIP-, and VRF-aware multicast
● Unicast Reverse Path Forwarding (uRFP) with ACL; strict and loose modes
● Jumbo frame support (up to 9216 bytes)
● Support for up to 16 fabric extender on each Nexus 5500 with L3 modules
● RFC 896
|
QoS |
● Layer 2 IEEE 802.1p (CoS)
● 8 hardware queues per port
● Per-port QoS configuration
● CoS trust
● Port-based CoS assignment
● Modular QoS CLI (MQC) compliance – IPv4 and IPv6
● ACL-based QoS classification (Layers 2, 3, and 4)
● MQC CoS marking
● Per-port virtual output queuing
● CoS-based egress queuing
● Egress strict-priority queuing
● Egress port-based scheduling: Weighted Round-Robin (WRR)
● Control Plan Policing (CoPP) – IPv4 and IPv6
|
Security |
● Ingress ACLs (standard and extended) on Ethernet and virtual Ethernet ports
● Standard and extended Layer 2 ACLs: MAC addresses, protocol type, etc.
● Standard and extended Layer 3 to 4 ACLs: IPv4 and IPv6, Internet Control Message Protocol (ICMP and ICMPv6), TCP, User Datagram Protocol (UDP), etc.
● VLAN-based ACLs (VACLs)
● Port-based ACLs (PACLs)
● Named ACLs
● Optimized ACL distribution
● ACLs on virtual terminals (VTYs)
● ACL logging on management interface
● Dynamic Host Configuration Protocol (DHCP) snooping with Option 82
● Dynamic Address Resolution Protocol (ARP) Inspection
● IP source guard
● DHCP relay
● Cisco CTS (Authentication and Policy download from ACS)
● Ethernet Port Security
● IPv6 RACL
● IPv6 PACL
● IPv6 VACL
|
High-Availability Features |
● In-Service Software Upgrade (ISSU) for Layer 2
● Hot-swappable field-replaceable power supplies, fan modules, and expansion modules
● 1:1 power redundancy
● N:1 fan module redundancy
|
Management |
● Switch management using 10/100/1000-Mbps management or console ports
● CLI-based console to provide detailed out-of-band management
● In-band switch management
● Locator and beacon LEDs on Cisco Nexus 2000 Series
● Port-based locator and beacon LEDs
● Configuration synchronization
● Module preprovisioning
● Configuration rollback
● Secure Shell Version 2 (SSHv2)
● Telnet
● AAA
● AAA with RBAC
● RADIUS
● TACACS+
● Syslog (8 servers)
● Embedded packet analyzer
● SNMPv1, v2, and v3 (IPv4 & IPv6)
● Enhanced SNMP MIB support
● XML (NETCONF) support
● Remote monitoring (RMON)
● Advanced Encryption Standard (AES) for management traffic
● Unified username and passwords across CLI and SNMP
● Microsoft Challenge Handshake Authentication Protocol (MS-CHAP)
● Digital certificates for management between switch and RADIUS server
● Cisco Discovery Protocol Versions 1 and 2
● RBAC
● Switched Port Analyzer (SPAN) on physical, port channel, VLAN, and Fibre Channel interfaces
● Encapsulated Remote SPAN (ERSPAN)
● Ingress and egress packet counters per interface
● Network Time Protocol (NTP)
● Cisco GOLD
● Comprehensive bootup diagnostic tests
● Call Home
● Smart Call Home
● Cisco Fabric Manager
● Cisco DCNM
● CiscoWorks LAN Management Solution (LMS)
|